Had a list of different items that needed finishing tonight. First I needed to finish up the support beams between the floors, now that I had the supplies I needed.

Cut the rest out and glued them in.

Then glued the sub-floor to the base floor. Also painted the edges of the pantry black so there would be no white cracks showing on the edges of the tiles.

Glued on the last two treads of the staircase.

Painted the bottom of the pantry walls brown and the top cream.

Next I touched up a couple tiny mistakes on the tiles I had painted. Sprayed them with acrylic to protect them. And painted some of the trim for the walls.

Placed everything back in the house (the wall trim is only taped on)…still haven’t cut out the back wall, but I put a white piece of cardboard to show where it’ll be. It’ll look more appropriate when it’s brown and cream like the rest of the walls…

….starting to look more like a pantry now. Here’s a view from the kitchen side (excuse the reflections on the plexiglass).

Traveling the next few days, but I’ll be back again soon.  Good night.

Got back to work painting the tiles tonight.

Amazing how much time each little one takes to paint correctly.  First I finished off the black ones.

Added the yellowish cream ones…

Continued on with the russet ones…

And there it is.

It’ll fit quite snuggly onto the pantry floor…

Which I’m hoping will both contrast with and match the pattern and colors in the kitchen next door.

Of course the whole thing will look better without all the masking tape holding it up, but here’s what I have so far…

Good night.

Started on the tiles for the floor of the pantry under the stairs. Tried out a pattern with a few colors that matched the tiles in the kitchen.

Decided to go with the lighter of the two yellows. Then I drew out the pattern on a piece of cardboard the size of the floor.

Scored the lines between the tiles with a utility knife.

Then started painting…

…and painting.

Still a long way to go, but I think I like the way it’s turning out.

I think I might run the green wainscoting from the kitchen into the pantry, too….but I’ll see. Maybe I’ll make it brown instead…more utilitarian.

For now, good night.

Since I had made the stairs the wrong size a little while back, I had to start fresh.

First I cut out the inner stair walls which would reach up to the very top of the house. Added the wooden studs to support them.

Glued the other side of the wall on and weighed it down.

Placed it in the house…

…and turned the lights on for a bit of fun.

Then I made a new design for the stairs, using the correct width, and fixing a few conceptual mistakes I had made the first time.

Cut out the various pieces.

Stained them.

Then glued them together, except the last two treads. (It takes a while to hold them as the glue dries and it’s way past my bedtime…so the rest will be done tomorrow.)

Placed them in the house (you can see the cracks where the two top treads are just laid on).

Fits much better than the first set of stairs, and I’ve done a much neater job of it all around.

Plenty more to go, but here’s a view looking down the inner wall for now.

Good night.

Began to build the back stairs this evening. Started by computing and drawing out the stairs on the side of the wall.

Created the framework for the stairs.

Added the risers.

Cut out the treads and rounded off the front of each one.

Stained the lot of them.

And glued the staircase together.

Then I placed it into the stairwell to see how it would work.

Placed it on the upper half to see how that would look.

But I noticed there was a bit of a fit problem.  So I added a temporary wall and studs where the center wall would be…

…and realized I had made the stairs too small. Turns out I measured off the length of a beam with floor and ceiling as opposed to the length of two walls and a stud; I’m an eighth of an inch off.  Sigh.

So I’ll be trying this over again…hopefully I’ll do a better job then.

For now…good night.

Started working on the back stairwell today.

Added the studs to support the walls…took a while to line them up correctly with the back part of the house.

Finished the last wall.

So here’s the stairwell.

Added the ceiling and floor of the landing (can’t add the beams between the two since I’m out of supplies).

Placed a few pieces of cardboard to see what the stairs and walls would look like before starting on the stairs.

I think I like the result, so next time I’ll work out how to make the stairs.

Be well.

Started cutting out walls for the rooms on the east side of the house tonight.

Walls for the back stairwell:

Walls for the formal drawing room:

And walls for the front sitting room:

From the side, then, the view will be the back stairs (the stairs will come up from the door on the left, with a landing halfway up, and end in the back on the right above the doorway…under the stairs, there will be the kitchen pantry and the wine cellar)…

…the drawing room (with a view of the dining room behind…the two small diagonal walls on both sides in front will have windows as part of a bay window area)…

…and the sitting room (the octagonal tower section will be full of windows, as will the left wall and the drawing room wall on the right, so the walls won’t look quite so solid and imposing).

Which will end up a bit like this:

And like this from the other side of the house:

These front rooms, as they are more formal and built to impress, are a good two inches taller than the back rooms, which explains why I needed to add a few steps in the upstairs hallway so I could connect the front and back hallways correctly.

A couple views from above…

And one of the front of the house, which will be full of windows (and, of course, a front door) when it’s finished.

Good night.